The roving frame plays a key role in the textile industry. How to make good use of the roving equipment? Roving tension and process control are essential.
Control of roving tension
1
In order for the roving to be smoothly wound onto the roving bobbin, the winding speed of the bobbin must be slightly higher than the speed of the output roll of the front roller, so tension and tension draft are generated on the sliver between the front roller and the thick tube. It is the key to roving production, which not only affects the roving life, but also directly affects the quality of the finished yarn.
2
According to the requirements of spinning quality, the maximum elongation is generally not more than 3%. The difference in elongation between yarns of the same machine size, front and back rows, and machines of the same variety should be controlled below 1.5%. Better.
3
The sliver from the front roller to the top of the spindle has a small twist and a long distance due to the sag phenomenon. At the same time, when the spindle is rotating at high speed, there is a shaking phenomenon, which is most likely to cause accidental extension. According to experience, it should be adjusted: when the small yarn is wound from the winding point to the lower layer of the bobbin, the sliver may be slightly shaken, but it is advisable to not wave. If the upper yarn is tight, which means that the winding speed is too fast and the elongation is too large, the starting position of the bevel pulley belt should be moved up to the large end of the bevel pulley. No bevel pulley is controlled and adjusted from the inverter. Slight jitter. If the sliver is gradually tightened during spinning, it means that the tapered belt moves too little each time, and the number of tension teeth should be reduced, otherwise the number of tension teeth should be increased.
4
The factors that affect the change of roving tension include: roving basis weight, front roller speed, twist, raw cotton quality, temperature and humidity, and mechanical conditions. Therefore, a roving quality account should be established in production, which is absolutely necessary to ensure production. The size, difference and unevenness of roving tension will affect the unevenness and weight unevenness of the roving. It is an important index affecting the quality of the roving, so it must be strictly controlled. Because the number of fibers in the cross section of the roving is much less, and the twist is lower than that in the spun yarn, after undergoing a large tension, it is easy to produce unexpected elongation, deteriorate the uniformity of the roving sliver, and increase the end break.
5
When the tension difference is large, the roving weight unevenness obviously increases, and generally should be controlled within 1.0%. When the roving tension is small, the roving is formed loose, and it is difficult to store, transport, and unwind, which affects the quality of the roving itself and also increases the uneven weight and deviation of the spun yarn. For example, when spinning pure cotton roving on a roving frame with a poor false twisting effect, the quality index of the front row is worse than the back row. Under the same spinning conditions, different tensions in the front and rear rows will cause quality differences. Of course, under the condition that the false twist effect is better, the tension of the back spinning may be greater than that of the front. Therefore, in terms of roving quality management, in addition to paying attention to the drafting part affecting quality, you should also grasp the changes in roving tension.






