Sep 30, 2020 Leave a message

Development of 60-Count Cotton Polyester Filament Core-spun Yarn and Research on Its Yarn-forming Properties

Coating effect

The cross-section of a typical core-spun yarn is shown in Figure 1. It can be seen from the figure that the covering effect of the core yarn in the middle of the core yarn is better; while the covering effect of the eccentric or exposed core yarn is poor. This is related to the amount of covering, the structural properties of the outer fiber, the spinning process of the fiber, especially the core yarn tension, twist, spindle speed, the position of filament and short fiber strands when they meet at the front jaws of the spinning frame, and it is reasonable. The twisting and winding equipment, the correct operation method and so on.

Generally speaking, in order to grasp the quality of the coating effect, we often grasp the core yarn content by quantitatively testing the blending ratio, and detect the eccentricity through methods such as microscopic observation or dyeing. However, the test method used to test the blending ratio of ordinary polyester-cotton yarn is not accurate enough, and the cross-section of the core-spun yarn cannot be known, and it cannot provide a more comprehensive quality status. Generally, the image observed with ordinary biological microscope is not clear enough when the magnification is below 400 times. Therefore, we mainly use a video zoom microscope to test the covering effect of the core-spun yarn. This test method can clearly observe the longitudinal covering form of the core-spun yarn and the distribution of the outer fiber and core yarn on the cross-section of the core-spun yarn. Simple and fast, and high accuracy.

There are two major difficulties in spinning 60-count cotton polyester filament core-spun yarn. Because the yarn count is fine and the outer fiber is small, the covering effect and the negative effect of large draft must be solved.

The content of core filament is controlled in the process (when the core filament is 50D, the covering amount is 50%~70%), the outer fiber material of better quality is selected, the drafting and twisting process is optimized, the speed is reduced, and the tension of the core filament is reasonably controlled (10CN), adjust the position of the guide wheel to make the relative position of the core wire and the outer short fiber beard is correct and reasonable, etc., reasonable configuration of pressure rods, imported travellers, etc. are indeed feasible measures to improve the covering effect of the core yarn .

To solve the negative effect of large drafting of 60-count cotton polyester core-spun yarn, it is necessary to select advanced equipment such as low-hardness and high-elasticity rubber rollers, pressure bar upper pins, and pay attention to the pre-spinning process.

The covering effect of the core yarn and the amount of covering, the structural properties of the outer fiber, the spinning process of the fiber, especially the core yarn tension, twist, spindle speed, filament and short fiber strands at the front jaw of the spinning machine The location at the time of merging, the reasonable twisting and winding equipment, and the correct operation method are closely related.

The strength and evenness of core-spun yarn are different from ordinary yarn. Although the strength of the core-spun yarn is closely related to the twist, it mainly depends on the strength of the polyester filament itself, and the outer fiber has relatively little influence. Due to the combination of core yarn and covering yarn during core-spun yarn processing, the evenness of core-spun yarn is better than ordinary single yarn under normal circumstances.



Send Inquiry

whatsapp

Phone

E-mail

Inquiry