1. Before the succession, the labor protection supplies must be neatly dressed, and the tubular squatting machine should be delivered to the post in advance, and the counterparts should be handed over, and they are not allowed to leave the post.
2. Before driving, the driver must personally check the integrity of the equipment, oil pressure, water pressure, and air pressure. If abnormal driving is not allowed, the person should be notified in time.
3. The operator must be familiar with the functions and usage of all the buttons of the console, as well as their operating procedures, requiring mental concentration and preventing mistakes.
4. When driving, the person must control the console. If the two are manipulating, they must cooperate with each other. The two sides can communicate with each other after the communication number. If some problems occur, they should be reported to the person in charge for repair and not allowed to start.
5. It is strictly forbidden to place repair tools and other items on the equipment (twisting machine, induction furnace, console). In order to avoid accidents during the operation of the device.
6. When working on the word wheel, the operators need to cooperate with each other, put them into the basket correctly and smoothly, and the operator should stand on the side to prevent accidents.
7. After the I-shaped wheel enters the basket, the operator should adjust the tip to the position and lock the spring pin. When threading, the two people should operate and cooperate with each other. The wire head is taken from the wire frame and passed through the guide wheel along the rotor. After the outer edge passes through the nozzle splitter disc, it is tightened in front of the former to prevent the steel wire from being retracted and injured, the protective cover is closed, and the brake device is locked.
8. The twisted wire of the twisted steel strand is wound around the steel strand outside the splitter disc, and the head is fixed so that it cannot be erected. Stop parking immediately.
9. Normal operation of steel strands should be patrolled to check the operation of the wheel. If there is excessive vibration, it should be stopped immediately for repair, otherwise it is not allowed to drive.
10. When the layer is wound, the end of the steel strand must be pinned. When driving, the operator cannot stand in the position of the winding machine to prevent the flying head from injuring people.
11. Wear protective glasses when cutting steel strands with manual grinding wheel. When the grinding wheel is less than one-half, replace it in time. Check the power supply before use. If the problem is found, replace it or repair it in time to prevent accidents.
12. The door of the console switch cabinet must be in a closed state to prevent accidents caused by chaotic lines, dust and debris.
13. If there is a problem during the tanning process, the parking button must be pressed during the processing of the tamping machine, and the inertial movement of the bow plate is stopped through the observation window to ensure that the car is stopped before the protective door can be opened for manipulation.
