The automatic winder often has some problems in the process of knotting, and four types of solutions are summarized in the repair process.
One: high failure rate
Reasons and solutions:
1. The quick connector of the untwisting tube or the twisting tube is not connected, and reconnecting is enough.
2. Insufficient solution, the performance is that the length of the solution is short, and the solution should be adjusted outward to increase the intake air volume; the adjustment should be in units of 0.1 mm. When the solution is not sufficient, it can also be solved by rotating the untwisting tube. The Z-twisted yarn rotates counter-clockwise to untwist the tube, and the larger the twist, the larger the amount of rotation.
3, the length of the knot is too short, adjust the length of the knot, Ln from Ln8 to Lnl, JC40 ~ JC60 varieties are generally adjusted in Ln3.
Two: Twisting knot is easy to slip off
Reasons and solutions:
1. If the pressure is too low, the pressure of twisting should be increased appropriately. Depending on the type of yarn and the number of yarns, the adjustment spring is 0.196~0.637MPa, and the high cotton yarn is generally 0.4MPa.
2, the length of the knot is too long, adjust the length of the knot, Ln from Lnl to the inside to Ln8.
3, the solution is insufficient, the solution is the same as above.
Three: thin and strong
Reasons and solutions:
1. If the twisting pressure is too high, the twisting pressure should be reduced, and the adjustment amount is 0.196~0.637MPa.
2. The length of the knot is too short, and the adjustment Ln is from Ln8 to Lnl.
3, the solution is over, the performance is that the length of the solution is too long and the head is fine and chaotic. The solution should be adjusted inward to reduce the intake air volume. The adjustment should also be in 0.1 mm. The long tail of the knot ends is caused by the length of the shackles being too long, that is, the Ln position is too far forward, and Ln should be dialed inward, and the strength of the knot is detected to determine the optimal position.
Four: The knot is thick and has a trailing tail.
Reasons and solutions:
1. If the knotted scissors are bad, remove the flying flowers at the scissors or replace the scissors;
2, the lower yarn or the upper yarn is poorly clamped, which may be caused by the flying yarn at the yarn guiding rod or the yarn guiding yarn, so that the clamping action is not in place, and the removal of the flying flower or the replacement of the yarn guiding rod can be solved;
3, single-sided untwisting tube position is bad, only need a little adjustment.
Through a series of targeted repairs, we found that the quality of the yarn knots was significantly improved and the joint failure rate was reduced to less than 10%.






