As one of the core work areas of carding machine, the feeding taker in roller working area has the function of pre carding the fiber layer, removing dust and short fibers, and reasonably controlling the air flow and related process parameters are the key to improve the impurity removal efficiency of carding machine and improve the product quality.
1、 Influencing factors and control measures of noil after machine
1.1 effect of licker in speed on noil
The centrifugal force on fibers and impurities is directly proportional to the square of rotation speed. Therefore, increasing the speed of taker in roller is beneficial to carding bundle, exposing impurities, increasing centrifugal force of impurities, increasing noil and impurity removal efficiency, but it is not conducive to transferring fiber to Xilin.
1.2 influence of height and angle of dust remover on noil
When the position of feeding plate and small leakage remains unchanged, lowering the position of dust removal knife will increase the length of the first litter area, which will make larger impurities have more opportunities to fall. At the same time, the air flow boundary layer in the first litter area is thickened, and the impurities floating in the boundary layer are more blocked by the dust removal knife. Although the amount of cotton in the second litter area is less, the total droppings rate of the rear belly still increases.
1.3 effect of taker in carding board on noil
The separation between the carding board and the taker in roller is small, the thickness of the boundary layer cut off at the entrance is large, and more falling objects fall into the car belly. Therefore, when the impurity content is high, the inlet spacing of carding board should be reduced to avoid too much impurities entering the taker in card board.
1.4 effect of small bottom leakage and licker in distance on noil
With the increase of inlet spacing, the air flow into the bottom of the small leakage increases, and the droppings in the small leakage area will increase. However, due to the decrease of the litter in the second litter area, the total noil rate decreases and the noil impurity content increases.
The gap between the small leakage and the taker in roller should be appropriate. Too small is not conducive to the elimination of short fibers, and too large is easy to cause the triangular area to hang flowers.
Influence of suction hood of 1.5 licker in roll on air flow
The air flow driven by the taker in roller and cylinder converges at the triangle area. When passing through the gap point between the taker in roller and the cylinder, one part enters into the back cover plate with the cylinder, and the other part enters into the taker in cover. The gap between the manual taker in roller and the feeding board is very small, so the air flow is difficult to pass through. Therefore, a high pressure area is formed under the taker in cover, and a large amount of gas will overflow, because there are short fibers in the gas If it is not handled properly, it will cause the phenomenon of winding roller and seriously affect the quality of the sliver.






