The rollers and rollers on the comber rotate at high speeds and are prone to generate static electricity. Dust in the air, impurities in the drafting area, and a small amount of fibers in the cotton web are easily absorbed and entangled on the rollers and rollers under the action of static electricity. If a cleaning device (such as a cleaning rubber sleeve) between the roller and the roller is used for a long time, it will be easily deformed by heat, which makes the rubber sleeve and the rubber roller have poor contact, and further entanglement occurs. If the entangled impurities cannot be removed in time, the already stretched cotton net will be entangled on the rollers and top rollers, which will cause the equipment to stop running, greatly reducing the work efficiency and increasing the work intensity. In order to solve the problem of entanglement in the drafting part of the comber, the equipment can be appropriately improved. The specific method is as follows:
1. Collect the used rubber ring of the spinning frame and use fish ball glue to paste it on the steel stripper, so as to replace the original clean rubber cover, realize the surface contact between the rubber ring and the rubber roller, and reduce the problem of rubber roller entanglement. .
2. Collect the cleaning rubber sleeve replaced in step 1 above, and refit it on the first roller stripping cotton rod assembly, so that the cleaning strip on the stripping cotton rod assembly and the roller are also changed into surface contact, the roller The entanglement problem can also be reduced.
3. The photoelectric switch detects the sliver winding stop device of the switch to be integrated with the electrical machinery. The grounding ring wire and the piston rod wire are connected to the machine. When the roller and rubber roller are entangled, the piston rod contacts the ground ring and the line is connected , The equipment will signal in time and stop quickly. The equipment under this method is sensitive in response and has a fast transmission signal, which can avoid the thick cotton web wound between the rubber roller and the roller due to the delay of the stop signal, and effectively protect the rubber roller and roller from being damaged. The effect of reducing the operator's cleaning time is obvious.
